home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
1,000 Game Manuals
/
1000gamemanuals.iso
/
Colecovision
/
Roller Controller.txt
< prev
next >
Wrap
Text File
|
2001-10-17
|
6KB
|
139 lines
ColecoVision Instructions
for the
Roller Controller
-------------------------------------------------------------------------------
Exciting High-Speed Action on Your ColecoVision Game System!
HOOKING UP YOUR ROLLER CONTROLLER
1. Unplug and remove the Hand Controllers from the ColecoVision Console
unit.
2. Plug a Hand Controller into the socket inside a Hand Controller Well of the
Roller Controller
3. Wind the Hand Controller Cord neatly inside the Well, then slide the bottom
of the Hand Controller into the Well. When Hand Controller is in place, push
the top of the Hand Controller down until it snaps into place. Attach the
other Hand Controller to the Roller Controller in the same manner The Hand
Controller jacks will fit only one way--DO NOT FORCE them into the
controller sockets.
4. The WYE Connector Cable jacks have the number 1 molded on top of one jack
and the number 2 molded on top of the other jack. Plug jack # 1 into the
rear socket, then plug jack #2 into the front socket inside the Hand
Controller storage compartments of your ColecoVision Console unit as shown
in illustration. Be sure the numbers are facing up when you are plugging in
the jacks.
5. Plug the Power Adapter Plug from the Roller Controller unit into the Power
Supply socket in back of your ColecoVision Console unit.
6. Plug the jack of the AC Power Supply unit into the back of the Power Adapter
Plug as shown in illustration. Plug the AC Power Supply unit into a 110/120
volt household electrical outlet. Make sure the Power Supply is fully
inserted into the electrical outlet.
7. MODE SWITCH: The function of the MODE SWITCH is to select between a Joystick
cartridge and a cartridge designed exclusively for use with the Roller
Controller. Slide the MODE SWITCH to the ROLLER Cartridge position when
playing roller-game cartridges. The JOYSTICK Cartridge position can be used
with most games that require use of the hand controller Joystick. Some
Joystick cartridge games will be more challenging than others when played
with Roller Controller Get the "feel" of the game before you decide to use
Roller Controller to play a Joystick cartridge game.
Now you are ready to begin playing your game! BE SURE THAT THE COLECOVISION
UNIT IS OFF BEFORE INSERTING OR REMOVING CARTRIDGE. Refer to your GAME
CARTRIDGE Instruction Guide for game play instructions.
WARNING: ALWAYS UNPLUG THE POWER SUPPLY FROM THE 110/120 VOLT OUTLET WHEN YOU
HAVE FINISHED PLAYING.
CARE OF YOUR GAME
Treat your COLECOVISION ROLLER CONTROLLER with care.
Before inserting or removing GAME CARTRIDGE, always make sure that the POWER
SWITCH on CONSOLE unit is turned "OFF".
Always unplug the POWER SUPPLY from the 110/120 volt outlet when you have
finished playing. IMPORTANT: ONLY CONNECT THE CONSOLE POWER SUPPLY UNIT INTO
A 110/120 VOLT HOUSEHOLD ELECTRICAL SERVICE, OTHERWISE SERIOUS DAMAGE MAY OCCUR
TO ELECTRICAL PARTS OF THE SYSTEM.
Do not drop or bang ROLLER CONTROLLER, CONSOLE or HAND CONTROLLERS.
Do not use sharp or pointed object to activate KEYPAD BUTTONS or GAME ACTION
BUTTONS.
Do not store or leave ROLLER CONTROLLER, CONSOLE and accessories where they may
be subject to heat build-up.
Keep away from moisture. Do not immerse ROLLER CONTROLLER, CONSOLE or HAND
CONTROLLERS in water Use a soft, slightly damp cloth to wipe clean.
WARNING: Before cleaning ROLLER CONTROLLER, CONSOLE and accessories, turn POWER
SWITCH to "OFF" and disconnect the AC POWER SUPPLY unit from the 110/120 volt
wall outlet.
Do not attempt to repair ROLLER CONTROLLER. It does not contain any owner
serviceable parts. Refer to your TROUBLESHOOTING section, if not successful
refer to LIMITED WARRANTY
NOTICE
This game generates and uses radio frequency energy and if not installed and
used properly, that is in strict accordance with the instructions, may cause
interference to radio and television reception. It has been type tested and
found to comply with the limits for a Class B computing device in accordance
with the specifications in Subpart J of Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that interference
will not occur in a particular installation. If this game does cause
interference to radio or television reception, which can be determined by
turning the game off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient the TV antenna.
Relocate the game with respect to the TV
Move the game away from the TV
PIug the game into a different outlet so that game and TV are on different
branch circuits.
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions. The user may find the
following booklet prepared by the Federal Communications Commission helpful:
"How to Identify and Resolve Radio TV Interference Problems".
This booklet is available from the U.S Government Printing Office, Washington,
DC 20402, Stock No. 004-000-00345-4
TROUBLESHOOTING
SYMPTOM REMEDY
---------------------------- ----------------------------------------------
Snow Make sure that both connections for
the power supply are secured in
their proper ports.
No Hand Controller Response Make sure that the switch on the
Roller Controller console is in the
"Joystick Cartridge" mode.
Roller Response Backwards Make sure that the controller plugs
are inserted into the correct ports on
the ColecoVision Main Console.